Fieldview

04/07/2026

This was the first take, I unexpectedly had my laptop set to extend display, not duplicate like I was expecting, which was when I cut the video short. Also brain far with UBSC vs USB mini. But everything works and I am happy to send it out!

11/28/2025

Found this for charging a laptop. Also, I can add a qi charger under the panel so it charges without it being seen. I would have to put a sticker or engrave the spot where it is. Just an idea.

11/10/2025

Still haven't sold one of my streaming boxes yet. I could if I took a loss, but I don't want to do that.

In the meantime, I am spending more time time on my side hustles. The cards below are joke cards I made. It's super fun.

11/04/2025

Been very busy lately. My main job has been taking more of my time and my other side hustle is starting to make money. Unfortunately, this has not yet, but I will get back to it at some point.

10/18/2025

10/18/2025

Will it fit? I dismantled the prototype of the drone live stream box. Let's see if I can fit this all.

10/18/2025

Finally getting back to work on this. I was on parent duty all week and my side hustle was moving.

I will work on my main box today, in the Pic. I will make it much prettier and remove the rocker panel. It's useless.

10/10/2025

I have been pretty busy with real life, but I just received my Neutrik hdmi connectors. I am going to install these soon. I am also going to fix up my 5g drone live stream box and try to sell that. I should have things done next week sometime. I will post the progress.

10/01/2025

Getting my fiber Laser dialed in for half mm 304 steel. Messing up a lot.

I ordered more than abs. I am going to remake my drone livestream station with fresh ABS. I am going to remove the rocker panel and replace it with the stream deck.

09/28/2025

I am holding off pouring more money into my atem cases. I am in the hole for about 1400 - 1600 on it all. If I sell one of them, I will rebuild what I sell, but I will make it better - battery powered, multi power input, qi charger, etc.

I have been missing in action for a little bit because I am doing a bit of overtime at my day job, and I had to push my other side hustle. During the day, I am spending a lot of time learning Microsoft SharePoint and power automate. I come home dizzy.

In the meantime, I am working on getting my laser engraver lenses calibrated. I have an old m2 maker gear 3d printer that I should get up and running. That can open up some more cool things to make. Here is my 120w Mopa. I have a lot of work to do yet.

09/21/2025

Added superfast charging port (2 USBA and 2 USBC)