10/07/2026
They make all sorts of dew heaters. Except I've never found a good one for the secondary mirror in a Ritchey-Chrétien. The reason is obvious in that most are rather bulky with thick wires. And that is less than ideal since it will interfere with the image circle. Last week we were above 85% humidity and even though the secondary points down, it was dropping below dew point and fogging terribly. I lost at least three nights to this. I do have a large dew heater around the base of the scope for the primary mirror and it works well. I made my own dew controller with a 12v thermostat from Amazon.
So, I did what every savvy astrophotographer does these days to solve this problem and queried AI. Google and I worked on this throwing ideas back and forth to finally arrive at this solution, which ends up being quite elegant. I'll detail the steps below.
Supplies needed:
Nichrome 80 wire
30AWG Magnet wire
1" wide Kapton tape with silicone adhesive
5.5x2.1 12v barrel connector
The diameter of the mirror cell is about 12" which is prefect for a 24" up and back run of the Nichrome wire which acts as the heating element. This length will provide about 54 Ohms of resistance and generate around 2.4W of heat.
Steps:
First wrap the mirror cell with one layer of Kapton tape to insulate the wire from contacting the metal cell. Then cut a strip off tape to 12" and lay sticky side up. Run the Nichrome wire up and back on the tape before putting it on the mirror cell. Be sure to leave about an inch or so sticking out for power connection. Be sure the wire does not touch itself anywhere along the path as this will cause a short.
Then cut two lengths of the magnet wire as long as you want. Magnet wire has a very thin enamel coating you'll need to remove. Remove the coating from both ends of the magnet wire. I found a small hobby file works best.
Connect the two pieces of magnet wire to each end of the Nichrome wire sticking out of the tape by wrapping. I found the wire difficult to work with since it's very thin. To test, I only wrapped the end of the wire and secured with tape by flattening on the side of the mirror cell. I had planned to solder, but honestly, this is working too well.
Finally, connect the 12v plug and test. If it works, then run the magnet wire across the top of one of the vanes. Reassemble the scope.
It's now ready to use with any dew controller. I plan to just plug it in during nights with high humidity and keep it on all night since the power draw is so little and it only keeps the mirror cell a few degrees above ambient. Also, do be done properly, a sensor would need run to the mirror cell to monitor temp for a controller to work as expected.
I've even considered getting these mass produced if there's enough interest.
Forgive the less than perfect taping job. I'm on disability with nerve damage and my fingers don't have the dexterity they used to.