08/05/2026
How to Install and Remove Lens Ports on Salted Line Camera Housing 🔧
Hey everyone,
Installing and removing lens ports is one of the most important skills when working with your Salted Line underwater camera housing. In this step-by-step guide, we show you exactly how it’s done, following the official method. ✅
This guide applies to Salted Line waterproof A7SIII, A7III/A7RIII, A7IV(GEN 1), A1 housings, and other supported models.
What You’ll Learn 👇
• How to correctly remove the dust caps
• How to handle the O-ring
• How to apply original Silicone grease
• How to install ports with locking tooth and without locking tooth (including lock pin)
• How to safely remove the lens port
Step-by-Step Installation 📋
1️⃣ Remove the dust caps
Take off the dust cap from the front of the Salted Line underwater camera housing and from the lens port.
2️⃣ Remove the O-ring (if necessary)
Carefully pull the large O-ring out of the groove on the lens port only if it is dirty and needs to be cleaned. Avoid stretching it.
3️⃣ Clean the O-ring
Wipe the O-ring thoroughly with a paper tissue.
4️⃣ Apply silicone grease
Apply a small, even amount of original Silicone grease to the O-ring.
5️⃣ Reinstall the O-ring
Place the greased O-ring back into the groove.
Now install the port - there are two types:
A. Port with locking tooth 🔩
• Align the locking tooth on the port with the corresponding notch on the housing.
• Push the port straight and firmly into the housing.
• Rotate the port clockwise until it is fully secured and the tooth locks in place.
B. Port without locking tooth 🔄
• Align the port with the alignment mark on the housing body.
• Push the port straight and firmly into the housing.
• Rotate the port clockwise until it is fully seated.
• Secure the port with the lock pin: insert the lock pin into the designated hole and tighten it with the provided screwdriver.
Step-by-Step Removal 🔄
1️⃣ If a lock pin was used - first remove it with the screwdriver.
2️⃣ Press and hold the release button on the side of the housing (not required for ports secured with lock pin).
3️⃣ Rotate counterclockwise until the port releases.
4️⃣ Pull the port straight out.
5️⃣ Put the dust caps back on both the housing and the lens port to keep everything clean.
For the full step-by-step guide, check out our video on YouTube 📺(https://www.youtube.com/watch?v=VKichgANHrA)
Final Thoughts 💡
Following these steps exactly as shown in the video will help you install and remove lens ports quickly, safely, and without leaks - whether your port has a locking tooth or not. Proper technique is the easiest way to keep your Salted Line underwater camera housing performing reliably dive after dive.
Have questions about lens ports, O-rings, or any other part of your Salted Line camera housing? Feel free to email us at [email protected] or message us on social media. We’re always happy to help.💙
👉 Discover the full Salted Line range, accessories and more at our official website: www.saltedline.com
Stay safe, stay dry, and happy shooting! 📸
- The Salted Line Team
Follow us for more tips, gear reviews, and epic underwater shots:
Instagram &
Facebook Salted Line & Salted Line Europe
Youtube Salted Line Waterproof Housings & Salted Line Europe
